Filter
Top Products
Using preset codes
13
Manually setting preset codes
1. Find your device in the supplied list of preset
codes.
2. Press and hold
to enter setup.
3. Press
.
4. Find the digit code number
from the pre-programmed
code list.
5. Use the number buttons to
enter the four digit code.
(Refer to the pre-programmed
code list table.)After you enter
the last digit, a double beep
sounds, confirming the code
has been input. If the number isn’t in the code
data base, the SRC-1600 will beep three times
continuously. Please try another number.
6. Check you have entered the correct code by
pressing Volume +/–, Channel +/– or
.
7. If the code is correct, press
to confirm
and exit. If the code is not correct, repeat
step 4. See Checking the code number on
page 14