Filter
Top Products
6-10
SUPERSERVER 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual
Reconfiguring the Power Supply
Although the standard configuration for the 6014P-8/6014P-82 and 6014P-
8R/6014P-82R is with single and dual (redundant) power supplies respec-
tively, you can reconfigure the 6014P-8/6014P-82 to hold two power supply
modules or (not recommended) the 6014P-8R/6014P-82R to hold a single
power supply module. The alternate backpanel section you will need for
either operation has been included with the system.
Note: in the following instructions, "right" and "left" refers to the side noted
when viewed from the rear of the system.
Reconfiguring the 6014P-8/6014P-82 (see Figure 6-6)
1. You will first need to power down the system and remove the power
cord. To gain access to the inside of the system, pull the server out from
the rack and remove the top chassis cover by following the instructions on
page 2-8.
2. Remove any expansion card that may be installed in the right-side riser
card.
3. Remove the three screws that secure the riser card bracket, which runs
from the primary ATX power connector to the rear of the chassis. After
the screws are removed, lift the riser card bracket out from the chassis.
Figure 6-5. Removing/Replacing the Power Supply