Filter
Top Products
3-2
SUPERSERVER 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual
3-3 Control Panel LEDs
The control panel located on the front of the SC814+S-560/SC814+S-R560
chassis has six LEDs, which provide you with critical information related to
different parts of the system. This section explains what each LED indi-
cates when illuminated and any corrective action you may need to take.
z UID: This LED turns on when either the front or the rear UID button is
pushed. Pushing either button a second time will turn this LED off.
z Overheat/Fan Fail: When this LED flashes it indicates a fan failure.
When on continuously (on and not flashing) it indicates an overheat condi-
tion, which may be caused by cables obstructing the airflow in the system
or the ambient room temperature being too warm. Check the routing of the
cables and make sure all fans are present and operating normally. You
should also check to make sure that the chassis covers are installed. Fi-
nally, verify that the heatsinks are installed properly (see Chapter 5). This
LED will remain flashing or on as long as the overheat condition exists.
z NIC2: Indicates network activity on GLAN2 when flashing.
z NIC1: Indicates network activity on GLAN1 when flashing.
2
1