Filter
Top Products
2-8
S
UPERSERVER 6015T-T/6015T-INF User's Manual
2-5 Checking the Serverboard Setup
After you install the 6015T-T/6015T-INF in the rack, you will need to open the top
cover to make sure the serverboard is properly installed and all the connections
have been made.
1. Accessing the inside of the System (see Figure 2-4)
First, release the retention screws that secure the system to the rack. Grasp the
two handles on either side and pull the system straight out until it locks (you will
hear a "click"). Next, remove the four screws (two on the sides and two on the top)
that secure the top cover to the chassis. Place your thumbs in the two rectangular
recesses and push the cover away from you (toward the rear of the chassis) until
it stops. You can then lift the top cover from the chassis to gain full access to the
inside of the server.
To remove the system from the rack completely, depress the locking tabs in the
chassis rails (push the right-side tab down and the left-side tab up) to continue to
pull the system out past the locked position.
2. Check the CPUs (processors)
You may have one or two processors already installed in each of the two server-
boards. Each processor needs its own heatsink. See Chapter 5 for instructions
on processor and heatsink installation.
3. Check the system memory
Your server system may have come with system memory already installed. Make
sure all DIMMs are fully seated in their slots. For details on adding system memory,
refer to Chapter 5.
4. Installing add-on cards
You can install two add-on cards to the system. See Chapter 5 for details on install-
ing PCI add-on cards.
5. Check all cable connections and airfl ow
Make sure all power and data cables are properly connected and not blocking the
chassis airfl ow. See Chapter 5 for details on cable connections.