DVR4-Advantage™ FAQs
Is the DVR4-Advantage easy to install?
The Swann DVR4-Advantage is designed with Do it Yourself installation in mind. Most people who can set up a VCR or
Home Theatre system will not have any problems installing the DVR4-Advantage. The plugs and cables do not need tools
to install and are a simple click, push or twist fit. Minimal tools are required to successfully install the DVR.
?
Is there a hard disk drive fitted to the DVR4-Advantage?
Yes, the DVR4-Advantage comes with an 80GB hard drive fitted, giving you 222 hours of continuous recording at 7 frames
per second.
?
www.swannsecurity.com
Enquiries: info@swann.com.au
Product Code: SW242-ADV
Monitoring Kits & Recording
How much hard drive is used when recording 4 cameras?
This table shows the hard disk consumption for an 80GB Hard Drive.
When selecting a Hard Drive You can calculate and estimate recording hours by using the following formula based on the
use of an 80GB Hard Drive.
80G Byte @ 7 frames per second @ Normal quality
80 (G byte) x 1024 (M byte) x 1024 (K byte)
15 (Kbyte/frame) x 7 (frame/sec) x 60 (sec) x 60 (min)
Estimate hours is 222 Hours
?
Format Quality Frame Size Frame Rate
30 15 7 1
NTSC HIGH 20 38 78 167 1165
NORMAL 15 52 103 222 1533
LOW 12 64 129 277 1942
25 12 6 1
PAL HIGH 20 46 97 194 1165
NORMAL 15 62 129 258 1553
LOW 12 78 162 323 1942
I have fitted a new hard drive to my DVR4-Advantage and it is working some times, but when I set it for
motion activation the hard drive stops working, what is causing this?
Make sure your hard drive is jumpered to “Master”. This is done using the small plastic jumper blocks that are on the pins
that are usually between the data socket and power socket on the end of the hard drive. Most hard drives come with an
instruction sheet on the correct jumper setting for “Master”, and many also have the information printed on the label on top
of the drive casing.
Also make sure that you have connected both the IDE and Molex connectors to your hard drive correctly and that there
are no bent pins.
?
Can I see pictures from all my cameras on my TV at the same time?
Yes. The DVR4-Advantage splits the screen into 4 sections so you can see each active camera in its own individual section
(up to 4).
You can also switch between each camera in full screen to view the images from that particular camera on its own in higher
detail.
?