Filter
Top Products
- 25 - EN
9J27
TROUBLESHOOTING GUIDE
If you have followed the instructions contained in this manual and have difficulty in operating your TV/VCR,
locate the PROBLEM in the left column below. Check the corresponding CORRECTIVE ACTION column to
remedy the problem.
PROBLEM CORRECTIVE ACTION
No power.
•
Make sure the AC cord is connected to an AC outlet.
•
Make sure the car battery cord is connected to vehicle’s cigarette
lighter socket and to DC 13.2V (12V) jack on back of the TV/VCR.
•
Check the fuse (5A, 250V) in car battery cord.
•
Make sure the power is turned on.
No picture and sound.
•
Make sure the AC cord is connected to an AC outlet.
•
Check antenna connection.
•
Let the TV/VCR program it's tuner memory.
No picture or poor picture on
•
Adjust direction or replace antenna.
TV/VCR.
•
Adjust picture controls.
No sound or poor sound.
•
Adjust volume control on remote control or main unit.
•
Press the MUTE button to restore sound.
Timer recording is not possible.
•
Make sure the timer recording is set correctly.
•
Make sure the power is off.
•
Make sure the TV/VCR clock is set correctly.
Cannot go into Record mode.
•
Make sure the tape has an erase-prevention tab. If need, cover the
•
hole with plastic tape.
Playback picture is partially noisy.
•
Adjust tracking control for a better picture using the CHANNEL K
•
or L button on the TV/VCR.
No picture but the audio is OK in
•
Head cleaning may be necessary. Refer to “AUTO HEAD
playback.
•
CLEANING” on page 24.
No operation by infrared Remote
•
Make sure the AC cord is connected to an AC outlet.
Control.
•
Check batteries in remote control.
Video or color fades in and out
•
You can not copy a copyrighted video tape. You are experiencing
when making a copy of a video tape
.
•
copy guard protection.
Can not set the auto clock to ON.
•
Make sure the AC cord is connected to an AC outlet.
Different color makes on screen.
•
Magnetism from nearby appliances and geomagnetism might affect
the color of the TV picture. Move the TV/VCR away from the appli-
ances, the TV/VCR can repair itself automatically. If you want to
repair immediately, unplug the TV/VCR power cord, then plug it in
again 30 minutes or so later.
T4400UA.QX33 03.1.28 11:37 AM Page 25