Filter
Top Products
- 10 - EN
9J27
INSTALLING THE BATTERIES
1)Open the battery compartment cover by pressing
the cover on the remote unit in the direction of the
arrow.
2)Insert 2 “AA” penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3)Replace the cover.
EXTERNAL INPUT MODE
When using an external input signal (another VCR or
video camera), connect the player’s audio/video out-
put cables to the AUDIO IN/ VIDEO IN jacks of
your TV/VCR. Then press the CHANNEL K or L
button until “AUX” appears on the screen.
AUX
MOBILE CONNECTION
NOTES:
•
Be sure your vehicle has a 13.2-volt (12-volt), neg-
ative-ground electrical system.
•
Be sure you use only the supplied car battery cord.
Using another cord could damage the TV/VCR.
•
Be sure the socket is free of ashes and other debris.
•
Be sure to push the car battery cord’s plug com-
pletely into the cigarette-lighter socket.
•
Always unplug the car battery from the cigarette-
lighter socket before you unplug it from the
TV/VCR.
•
You must disconnect the car battery cord from the
TV/VCR before you can use the AC power.
•
Be sure to replace the fuse with only the same type,
5A, 250V.
•
Be sure the AC cord is wound as shown below.
WARNING: The driver should never watch
the TV/VCR while operating a motor vehicle.
CAUTION: If you use the TV/VCR with the
vehicle’s engine off, recharge the vehicle’s
battery after about every 4 hours of use to
prevent it from running down. After you fin-
ish using the TV/VCR be sure you unplug the
car-battery cord from the cigarette-lighter
socket.
DC13.2V
ANT.
VHF/UHF Combination
Mobile Antenna
(Not supplied)
To the vehicle's
cigarette-lighter socket
Car battery cord
(Supplied)
1) The supplied indoor antenna is adequate when
your vehicle is stationary. For best reception on
the road, use a high-quality VHF/UHF mobile TV
antenna.
2) Attach the car battery cord to the DC13.2V (12V)
connector on the back of the TV/VCR. Then, con-
nect the other end to your vehicle’s cigarette-
lighter socket.