Filter
Top Products
2 D5018501
RCM or Blank Plate
X-Port 20
X-Port 10 Installation:
DC Power Connection to X-Port 10:
Logo Installation:
Apply the provided TANDBERG Director label to the top right hand corner of the Smart 3000i projector.
The label will help differentiate the type of system you have if and when technical help is required.
•
Remove the existing brackets from the X-Port 10
unit and replace them with the supplied left and
right brackets. Use the same screws for mounting
the new brackets.
•
Insert the four 10-32 panel nut retainers on the rea
r
left rack mount rail of the 3000i projector. Insert 1
panel nut retainer at the lowest hole, skip 1 hole
insert another, skip 6 holes insert another, skip 1
hole insert another.
•
Install the X-Port 10 unit to the exterior of the rac
k
within the 3000i projector. Use the supplied 10-32
x ¾” screws to fasten the X-Port 10.
•
Locate the DC power cable supplied with the X-
port 10.
•
Remove the Room Control Module (RCM) or the
blank plate and the X-Port 20 panel.
•
Connect one end of the DC power cable to the X-
Port 20 through the Room Control Module (RCM)
hole.
•
Bring the cable down from the side and connect the
other end of the DC power cable to the X-Port 10
connector labeled as Power Supply.
•
Fasten the cable using the supplied tie wraps to
prevent disconnection.
DC Power Connector