Filter
Top Products
Operation Mode Functions
TEAC 1x10 DVD Duplicator User’s Manual 11
Chapter 3. DVD Duplicator Functions
The DVD Duplicator features three (3) modes of operation:
❑
Operation
mode
❑
Setup
mode
❑
Advanced
mode
Operation Mode Functions
Operation
mode includes seven (7) functions. Each function is explained below.
Test
The
Test
function simulates writing to the target disc. The discs will remain blank
after the test is complete. This function is recommended if you are using
unsupported media. This function enables the target drive to adjust the laser to the
proper intensity. The source drive, which is determined by the setting on the
Duplicator controller, can be either the DVD-ROM drive or the hard disk drive.
Copy
The
Copy
function enables you to copy data from the source DVD or a partition
on the internal hard disk drive. For more information, refer to “Basic Operation”
on page 8.
Compare
The
Compare
function compares data on the source and target discs after the copy
process is complete.
Copy and Compare
The
Compare
function follows immediately as soon as the
Copy
function is
completed.
Verify
The
Verify
function verifies that the target disc was written completely and with
no errors.