Filter
Top Products
INSTALLATION OF MOUNTING FRAME ON SOLID CONCRETE OR CINDER BLOCKS.
OPTION 3
ø7.6 x 62 mm
IF YOU WANT TO
HANG YOUR TV
ON THE WALL,
FOLLOW THESE
STEPS.
18
1- Use the mounting frame as a template to mark six (6) holes on the wall. The outer holes must fall to left and right of the
four (4) small slots in the middle of the frame. Three (3) in the top row and three (3) in the bottom row of the horizontal supports. Make
sure these holes are level and there is at least 6” between any two holes.
2- Pre-drill these holes with a 1/2” masonry bit to at least 2 1/2” in depth. See detail #3.
3- Insert a concrete anchor (IHA0548) into each of these holes. Make sure the anchor is seated completely flush with the concrete surface
even if there is a layer of drywall or other material in front. See detail #4.
4- Attach the mounting frame to the wall using six (6) lag bolts (IHA0547) and six (6) washers (IHA0548). Make sure the horizontal supports
are oriented so the flat surface is against the wall and that a set of lag bolts is on each side of the four small slots as shown in detail #2,
only in this case, will have three (3) bolts per side. See detail #5.
TOOL REQUIRED:
Hammer, Impact Drill, 1/2” masonry bit, socket or wrench set, open wrench, level
DETAIL #5
TECHCRAFT highly recommends that you use a qualified
professional contractor to perform the entire installation.
TECHCRAFT is NOT liable for any damages or injury caused by incorrect use of the product
including use for a purpose not specified by TECHRAFT, incorrect mounting, incorrect assembly,
incorrect installation, or other failure to follow the instructions in this manual.
CAUTION:
Wall must be in conformity with building code. Ensure the wall has the capability to support the appropriate load bearing.
Do not use this product for any purpose or use not specified by TECHCRAFT.
INSTALLATION WARNING
If you do not understand these instructions or have any doubts about the nature or capacity of your walls or any doubts
about the safety of the installation, call a qualified professional contractor or contact Techcraft Manufacturing Inc. at
www.techcraft.net;
If the hardware you need is not included, please consult your local hardware store or contact us at www.techcraft.net
For the optimum viewing height, please consult the owners manual from your television manufacturer.
DETAIL #3 DETAIL #4
1/2" masonry bit
(TWO) 2 PERSONS ARE REQUIRED FOR
THIS STEP
CAUTION:
IHA0548
IHA0546
IHA0547
6”
min.
6”
min.