Technika LCD 46-259 Flat Panel Television User Manual


 
9
9
Attaching the stand
ATTACHING/DETACHING THE STAND
g 1
g 2
For optimum viewing,
if wall mounting the TV
higher than eye level,
the TV should be tilted
downwards so that the
TV’s screen is ‘face on’.
See fi g 1 and 2
Attaching the Stand
1) Insert the stand into the neck of the TV. 2) Secure the stand using the screws provided.
Detaching the Stand
1) To remove the base, press close and rotate 45 degrees.
2) Remove the 4 screws highlighted
IMPORTANT - Before drilling any holes in the wall ensure you are
not drilling where there could be any electric wires, water or gas
pipes. If in doubt please contact a qualifi ed tradesman.
Wall mounting the TV
1) Remove the four screws highlighted below.
2) The wall mount can now be easily attached to the mounting holes on the rear of the TV. These holes
are indicated in the picture below.
Important – If wall mounting this TV, only
use the screws already provided in the wall
mounting holes. Using other screws which
are longer could cause irreparable damage to
internal parts.
TV
TV
Viewing angle
3) Remove the screw/s in the neck of
the stand (where fi tted)
INCORRECT
CORRECT
User Guide - Technika - LCD 46-259.indd Sec1:9User Guide - Technika - LCD 46-259.indd Sec1:9 31-Oct-11 3:36:29 PM31-Oct-11 3:36:29 PM