TERK Technologies LF-UNIV Universal Remote User Manual


 
THE LF-UNIV INFRARED RECEIVER (BASE STATION)
Your Remote Control Extender receiver receives the radio
signals from the Leapfrog Transmitter module and converts
them back into the original infrared signals.
LF-UNIV Receiver Placement: Place the receiver
facing the components of your system. Extend the antenna.
Plug the 110V adapter into your household AC outlet
and insert the jack on the adapter into the receiver unit.
The LF-UNIV receiver will operate at any range from
3’ to 30’ from your components.
Your LF-UNIV Remote Control Extender is always “ON” -- ready to receive your every command!
Walls won’t stop the Remote Control Extender. You can use your remote control from almost anywhere!
Infrared Extension: The Extension can be used in situations where the Receiver
can not be placed in front of the component(s) it is controlling. This device
consists of an Infrared diode connected to a 8ft. extension wire and plug.
aim front towards components
LF-UNIV Receiver
TK1259/LF-UNIV OM/New 4/2/03 05:07 PM Page 3