Technicolor - Thomson 27LCDB03B Flat Panel Television User Manual


 
23
Connecting a Computer
Method A :
Connect the D-sub signal terminal on the back side of the LCD TV to the output of
PC equipment through min D-sub 15 pin cable.
Connect the stereo sound input jack on the back of the LCD TV to the audio output
terminal on the computer.
To display images from the connected computer, select PC using AV button on the remote
control
Method B :
Connect the DVI signal terminal on the back side of the LCD TV to the output of PC
equipment through min DVI cable.
Connect the stereo sound input jack (Audio input near DVI connector) on the back of
the LCD TV to the audio output terminal on the computer.
To display images from the connected computer, select DVI using AV button on the remote
control
Note:
1.
The display native resolution is 1024 x 768. If the signal resolution exceeds the native resolution, it may not
be possible to show fine detail with sufficient clarity.
2.
An adapter is required to use the PC cable (D-sub 15P) to connect a Macintosh computer to the set.
3.
Some PC models cannot be connected to the set.
4.
There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminals.
5.
Do not set the horizontal and vertical scanning frequencies for PC signals, which are above or below the
specified frequency range.
For more information about external device connections, see the manuals of your external devices.