Filter
Top Products
Connections
44
Interactive Setup
If you self-installed your satellite dish, you may have already used
the interactive setup to find the dish pointing coordinates,
acquire and fine-tune the signal, and run a system test.
If you need to run the interactive setup again, go to the
Assistance
menu and select
Setup
.
If you just want to check your dish pointing coordinates, or run
the signal strength meter, select
Dish Pointing
from the Main
menu.
Disabling Interactive Setup
The Interactive Setup menus automatically appear on-screen the
first time you plug in your receiver, and when power is restored
after a power loss.
The final step of the Interactive Setup allows you to disable the
automatic appearance of the Interactive Setup.
To enable it again, select
Setup
from the
Assistance
menu and
then follow the Interactive Setup routine until the end, where
you can choose to enable the automatic feature.