Filter
Top Products
GB
Continental
Europe
United Kingdom
The plug is fitted witha fuse which protectsyour
television.Ifyour television does notwork, the fuse may
be blown.In this case, replace it with an identical 5Amp
ASTAorlr BSI(BS1362)certified fuse.
Note:themainslead ofyour television is fitted with a
mouldedplug.Thislead contains allthesafety equipment,
so you areadvised when replacingitnottouse a
non-specific commercially-available model.
2
Basic connections
3
Basiccon nectio ns
The mains plug (1) supplies power to the television. The
television must only be plugged in to a 220-240 V - 50 Hz
power supply. It must never be plugged in to a DC source. If
the plug comes away from the lead, never attempt to plug it
in: this could cause electrocution.
Theaerialsocket(2), locatedon therearofthetelevision,can
be used to connect an external aerial or other appliance
equipped with amodulator such as a VCR, satellite receiver,
etc.
If you connect an appliance to the aerial jack, you must give
it achannelnumber.Todo this, switch onthe appliance, then
use the television to find the modulator channel (see the
appliance manual). Now give it a programme number and
memorise it (see Manual Programming of channels). Then,
when you wish to use the appliance, simply select its
programme number on the television. This procedure is not
required for VCR’s not equipped with a modulator.
The SCART socket AV1 (3), located on the rear of the
television, is intended to connect a VCR or a camcorder
(VHS, 8 mm), a Canal+ decoder, a video games console or
RGB-signal emitting appliances.
The SCART socket AV2 (3), located on the rear of the
television, is intended to connect a VCR or a camcorder
(VHS, 8 mm, S-VHS or Hi-8).
We strongly recommend the use of this type of connection,
which gives a better picture quality. To use the peripheral
appliancethat youhaveconnected, press theAV key onyour
remote control (press once to select AV1; twice to select
AV2; three times for AV3: see ”Other Connections”). This
selection is automatic for some appliances. Pressing “”play”
on a VCR, or switching on a satellite receiver connected to
AV1 or AV2 will automatically switch on your television.
When you stop the VCR, if you have not changed channels
while watching the VCR, the television automatically
switches back tothechannel you were watching beforehand.
If the television has been switched on from the VCR, it
switches to standby when the VCR is switched off. The
television automatically switches to 16/9 format if the
connected appliance delivers the corresponding signal.