Filter
Top Products
___________________________________________________________________________
page 19
The following settings are possible:
DYNAMIC HI (DTS + Dolby Digital)
High level limit: 0.0 (disable high level limit function)
0.1
0.2
0.4
0.6
1.0 (maximise high level limit function)
DYNAMIC LO (Dolby Digital)
Low level boost: 0.0 (disable low level boost)
0.1
0.2
0.4
0.6
1.0 (maximise low level boost)
6.7 Volume scale
It is possible to select two volume level settings: a progressive step size, where step
size is large at low levels for rapid setting and small at normal listening levels, or a
fixed 0.5 step size.
The progressive step size will be most convenient for most users and is therefore
called “normal” and selected as default, while the fixed step size is called “full”:
“normal”: 0.0, 5.0 , 10.0, 15.0, 20.0, 22.0, 24.0,......38.0, 40.0, 41.0,
42.0,..... , 68.0, 69.0, 70.0, 70.5, 71.0, 71.5, .... , 99.5, 100
“full”: fixed 0.5 dB step size from 0.0 to 100 ( 200 steps).
6.8 Saving set-up parameters in memory
In the menu MEM BANK, it is possible to store the set-up parameters in four
memory banks, one for each surround mode: Stereo, ProLogic II, Dolby Digital and
DTS.
Following parameters are saved:
- Channel volume trims (L, C, R, SL, SR, SUB and LFE)
- Channel delay (SL, SR, C, SC)
- Speaker configuration
When you have completed your settings for one of the four above mentioned
modes, you can save your settings by choosing the correct memory bank (Stereo,
ProLogic II, Dolby Digital or DTS) by pressing “⇒ “ and then press “ENTER”.
The saved parameters will be reloaded each time a surround mode is changed.
However, intermediate settings made “on the fly” will be maintained for each
surround mode until the PR350 B is powered off or set into standby.