Filter
Top Products
7/02, SatelliteToshiba TRR Page 12
Satellite 1400 Series Disassembly Overview, cont.
To remove the touch pad, follow the steps below.
1. Disconnect the touch pad SUMI card
from PJ2004 on the system board.
2. Remove one M2x5 silver thin flat-head
screw securing the touch pad.
3. LIft out the touch pad.
4. Disconnect the touch pad SUMI card
from CN1 on the touch pad.
!
To remove the battery board, follow the steps below.
1. Disconnect the battery cable from
PJ8810.
2. Lift out the battery board.
3. Disconnect the battery cable from
PJ8811 on the battery board, if neces-
sary.
NOTE: On installation, be sure to route the
battery cable under the battery board to avoid
pinching the battery cable with the plastic cover.
!
To remove the HDD connector board, follow the
steps below.
1. Remove two M2x5 silver thin flat-head
screws securing the HDD connector
board.
2. Carefully lift up the HDD connector
board to disconnect it from PJ2000 on
the system board.
3. Lift out the HDD connector board.