Filter
Top Products
English - 14 -
English
Initial Installation
Before switching on the TV, put your decoder and media recorder to Standby if they are connected and
ensure the aerial is connected to your TV. To set up the TV, use the buttons on the remote control as
detailed on page 7.
IMPORTANT: Ensure that the aerial is connected and
a Common Interface module is not inserted before
switching on the TV for the rst time installation.
1. Connect the mains plug and switch the TV to on
using the
/ I button. If the TV does not switch on,
press any numbered or button on the remote
control, then the language selection menu will
be displayed. This screen will appear the rst
time that the TV is switched on and each time
the TV is reset.
2. By pressing Up or Down button, highlight the
language you want to set and press OK button.
The following message will be displayed next:
3. By pressing Left or Right button, select the
country you want to set and press Down button
to highlight the Search Type option. Use Left or
Right to set the desired search type. Available
search types are digital only, analogue TV only
and full.
4. When set, Down button to select Teletext
Language. Use Left or Right button to select
desired Teletext Language.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.
You can activate Store mode (optional) option by
using “
” or “ ” button. If Store Mode (optional)
is selected, Store mode option will be available in
other settings menu and your TV’s features will be
illustrated on the top of the screen.A conrmation
screen will be displayed after selecting the Store
Mode (optional). Select YES to proceed.
If Home Mode is selected, Store mode (optional) will
not be available after the First Time Installation. Press
OK button on the remote control to continue and the
following message will be displayed on the screen.
Note: Home mode is recommended for normal
use. Select store mode when using a TV for display
purposes in a shop.
Note: Although this cable feature can be selected it
is not supported in Australia.
5. Select Aerial option from the Search Type screen,
the television will search for broadcasts.
6. The Auto tuning screen will appear and the
television will start to search for available stations.
The progress bar will move along the line. You
must allow the television to complete the search.
The following OSD will be displayed on the screen
and the television will search for the selected
broadcasts: