Filter
Top Products
13
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
1 In the code table on page 14, find the code for your brand of VCR or
cable TV converter.
If more than one code is listed, try each one separately until you find
one that works.
2 Set the TV/CABLE/VCR switch to VCR (for a VCR), or CABLE (for
a cable TV converter).
3 While holding down RECALL, press the Channel Number buttons
to enter the 3-digit code for your brand of VCR or converter.
4 To test the code, turn the VCR or converter on, point the remote
control at it, and press POWER.
–If the correct code was entered, the VCR or converter will turn off.
–If the VCR or converter does not respond, repeat steps 1–4 using
another code.
–If the VCR or converter does not respond to a different code,
you will need to use the remote control that came with your VCR or
converter.
5 Set the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the code(s) you used:
VCR Code:
Cable TV Converter Code:
Note:
You must reprogram the remote control every time the batteries are changed.
Some newer VCRs respond to either of two codes. These VCRs have a switch
labeled “VCR1/VCR2.” If your VCR has this kind of switch and does not respond
to the codes for your VCR brand, set the switch to the other position (“VCR1” or
“VCR2”) and reprogram the remote control.
Programming the remote control
Your Toshiba TV remote control is preprogrammed to operate most Toshiba brand VCRs and cable TV converters. To
program your TV remote control to operate a non-Toshiba device or Toshiba device it is not programmed to operate,
follow these steps:
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL MUTE
CH
CH
VOL VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REWPAUSE
FF
SOURCESTILL
PIP
SLOW
PIP CH LOCATE SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEOFAV CH
A
CT-90037
EXIT
RECALL
Channel
Numbers
POWER