Filter
Top Products
English - 10 -
Controlling the TV
A wide variety of external equipment can be connected via the sockets located on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the right side of the television may be used for some functions.
Switching on
If the standby LED is unlit, check that the mains plug is con-
nected to the power and press the
button on the left
side of the television to switch the television on. Then the LED
lights up white. If the picture does not appear, press on
the remote control; it may take a few moments.
To put the television into Standby, press
on the remote
control. To view the television, press again. The pic-
ture may take a few seconds to appear. Note: The active
Standby LED may appear for a few moments when the TV
is switched off.
Note: A beeping sound will be heard when the buttons
are pressed. This is normal operation, not a fault.
For energy saving:
Turning the television off at its mains supply, or un-plugging it, will cut energy
use to nearly zero for all televisions. This is recommended when the televi-
sion is not being used for a long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy use. Energy
effi ciency cuts energy consumption and thus saves money by reducing
electricity bills.
NOTE: Putting the television into standby mode, will reduce energy
consumption, but will still draw some power.
Using the Remote Control
Press the MENU button on the remote control to see the
menus.
In analogue TV mode the menu appears as a group of
icons each for a menu option. Press the Left or Right button
to select a topic.
In digital TV mode the menu appears as a list. Press the Up
or Down button to select a topic.
To use the options press the Up and Down buttons on the
remote control to move up and down through them and OK,
Left or Right buttons to select the required choice. Follow
the on screen instructions. The functions of each menu are
described in detail throughout the manual.
Using the Controls and Connections on the TV
Using the control buttons on the front of the TV:
• To alter the volume press + -.
• To alter the programme position press - P/CH + on the right
side of the TV.
• Press +
- buttons at the same to view main menu and
use - P/CH + to navigate and +
- to change value.
NOTE: The USB socket has limited functionality, and Toshiba
can take no responsibility for damage to other connected
equipment.
To select an external input, press SOURCE until the appropri-
ate input source is selected.
Please always refer to the owner’s manual of the equipment
to be connected for full details.
Menu OSD
Volume
Down/Up
Programme
Down/Up
AV/
Source
Standby
On/Off
Switch
Standby LED
00_MB35_[GB]_3910UK_IDTV_NICKEL1_40740W_(IB_QSG)_10069763_50176572.indd 1000_MB35_[GB]_3910UK_IDTV_NICKEL1_40740W_(IB_QSG)_10069763_50176572.indd 10 16.09.2010 09:36:4516.09.2010 09:36:45