Filter
Top Products
Chapter 5: Setting up your TV
27
the menu. (Also see item 2 on page 12 and
“Setting the PC Audio” on page 43.)
Viewing the digital signal meter
You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
1無
Press and open the Setup menu.
2無
Highlight Installation and press .
3無
A new set of Installation menu icons will appear.
Open the Terrestrial menu, highlight Signal
Meter, and press
.
4無
Press pqtu to select the antenna input and
digital channel whose signal you want to check.
Note:
•
The physical digital channel number listed in
the Signal Meter screen may not correspond
to a virtual TV channel number. Contact your
local broadcasters to obtain the RF channel
numbers for your local digital stations.
•
The signal strength does not change between
virtual channels on the same physical
channel.
To close the screen and return to the
Terrestrial menu:
Highlight Done and press .
To return to normal viewing:
Press .
Setting the time zone
The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the correct
time zone information ( page 48).
To set the time zone:
1無
From the Setup menu, highlight Installation and
press
. A new set of Installation menu icons
will appear.
2無
Highlight Time Zone, and press .
3無
Press t or u to select the region, highlight Done,
and then press
.
After the time zone has been set, you will be asked to
set the current Daylight Saving Time status.
To set the Daylight Saving Time status:
1無
Press t or u to select Yes or No, Highlight Done,
and then press .
Viewing the system status
To view the system status:
1無
Press and open the Setup menu.
2無
Highlight Installation and press .
3無
A new set of Installation menu icons will appear.
Open the System Status menu, highlight System
Information, and press
.
4無
Press tu to scroll through the menu bar to select
the Factory Defaults or Support Information and
view the related information.
To close the screen and return to the
Installation menu:
Highlight Done and press .
To return to normal viewing:
Press .
Reset Factory Defaults
To reset all settings and channels to their
factory default values:
1無
Press and open the Setup menu.
2無
Highlight Installation and press . A new set of
Installation menu icons will appear.
3無
Open the System Status menu, highlight System
Information, and press
.
4無
Press tu to scroll through the menu bar to select
Factory Defaults.
5無
Highlight Yes and press .
6無
(If PIN code has been set, enter your PIN code. Press
t or u to select Done and press
.) A warning
message will appear, select Yes and press
, the TV
will turn off automatically after a few seconds. After
the TV turns off, unplug the TV power cord and then
plug it in again to complete the reset process.
To cancel the reset:
Select No and press in step 5 above.