Filter
Top Products
58
Initial Setup and Menu
Network Setup
❖ 1 sec
3 Select the Test button.
A message screen will appear asking you “Was your device
changed from one channel to another by the IR blaster? If not,
please check your configuration.” If the test failed, a “Test
Failed” message will appear on the screen.
4 Once you have selected all the appropriate information on the
screen, use the ( / arrow) buttons to select the Done button.
To cancel this screen and return to the previous screen, select
the Cancel button.
❖ When the Done button is selected, if the TV input has already
been selected for another device an Alert Screen will appear.
❖ When the Done button is selected, if the HDMI input has already
been selected for another HDMI
®
CEC device an Alert Screen
will appear.
❖ When the Done button is selected, if the Device Type selected is
the Cable Box, Satellite Box or Blu-ray ™ DVD Player, the
following message will be displayed: “Are you sure you want to
apply this device to MediaGuide?” You must select the Yes or
No option using the ( / arrow) buttons. After this selection,
the IR Blaster Setup main screen will appear.
❖ The HDMI
®
CEC control function has priority over the IR Blaster
function when HDMI and HDMI
®
CEC devices are connected. If
the IR Blaster is already setup, the IR Blaster function should be
stopped when the same HDMI port is being used with at least
one HDMI
®
CEC device.
Network Setup
During the Initial Setup, the Network Setup screen will appear with
the message, “Network Setup will now begin. If you wish to skip,
please select Skip.” To start the Network Setup, select Next on the
screen or to skip the setup, select Skip. If you wish to skip this
setup, you can setup the Network at any time through the
NETWORK menu.
In order to setup your network, you must first select the type of
network you wish to set up:
NOTE