Filter
Top Products
Chapter 3: Using the remote control
23
Using the remote control to
control your other devices
If you have a non-Toshiba device or a Toshiba device that
the remote control is not preprogrammed to operate, you
must first program the remote control to recognize the
device (if you have not already done so) ( pages 25–27).
To use your TV remote control to operate a:
•
Cable converter box or satellite receiver, set the
MODE SELECT switch to CABLE/SAT.
•
VCR, set the MODE SELECT switch to AUX 1.
•
DVD player or HTIB, set the MODE SELECT
switch to AUX 2.
Note: Even after the TV remote control is
programmed, it may not operate certain
features on any other devices. If this happens
and you wish to use those features, you will
need to use the device’s original remote control.
16
17
19
18
Point the remote control
directly at the device.
1無
POWER
Turns the selected device on and off.
2無
Channel Numbers (0-9)
Press to directly access
channels (as opposed to ).
3無
+10
Press to directly access DVD chapters higher than
10.
4無
TOP MENU
Accesses a DVD’s top menu.
5無
CH
pq
For channels programmed into the channel
memory (
page 31):
p
selects the next higher channel.
q
selects the next lower channel.
6無
GUIDE
Displays the channel guide in the CABLE/SAT
mode.
SET UP
Accesses a DVD’s setup menu in the AUX
mode.
7無
INFO
Displays TV status information on-screen.
8無
pqtu
Press to navigate DVD menus (may not work
on some DVD players).
9無
ENTER
Required by some satellite receivers and DVD
players to activate certain functions.
10無
DVD CLEAR
Press to reset the title and chapter number.
11無
PLAY
Begins playback of a tape or DVD.
12無
PAUSE
Press during play or record mode to pause the
picture; press again to restart.
13無
STOP
Stops the tape or DVD.
14無
SKIP
Skips forward to locate later DVD chapters.
15無
FF
Fast-forwards the tape or DVD. (Press during play
mode to view the picture moving rapidly forward.)
16無
SKIP
Skips back to beginning of current DVD
chapter, or locates previous chapters.
17無
REW
Rewinds/reverses the tape or DVD. (Press
during play mode to view the picture moving rapidly
backward.)
18無
TV/VCR
To view one program while recording another,
press to select TV mode.
SEARCH
selects a specific DVD chapter, title or time.
19無
REC
Starts tape recording.
20無
MODE SELECT switch
Set to “TV” to control the TV;
“CABLE/SAT” to control a cable converter box or
satellite receiver; “AUX 1” to control a VCR; “AUX 2”
to control a DVD player or HTIB.