Toshiba 65HM167 Projection Television User Manual


 
55
HM67 (E/F) Web 213:276
Chapter 6: Using the TV’s features
Displaying TV status information
To display TV status information using RECALL:
Press E on the remote control.
The following information will display (if applicable):
Current input (ANT, VIDEO 1, etc.)
If ANT is the current input, either “CABLE” (for cable TV)
or “ANT” (for over-the-air broadcasts).
Channel number (if in ANT mode)
Channel label (if set)
Digital signal strength indicator (bar graph in lower right
corner of box; for ATSC signal only)
Stereo, Mono or SAP audio status (when HDMI input mode,
Dolby Digital or PCM)
Video resolution
Aspect ratio of incoming video signal (4:3 or 16:9)
V-Chip rating status
Lamp Mode ( : High Bright)
To close the RECALL screen:
Press E again.
To display TV status information using INFO:
Press
Q
on the remote control.
The following additional information will display for off air
digital channels (if applicable):
Title
Duration
Detailed description
Note: The location of the banner can be moved to the top or
bottom of the screen by pressing B or b while the RECALL or
INFO display is on-screen. (The last position will be stored to
memory.)
Understanding the auto power off
feature
The TV will automatically turn itself off after approximately
15 minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT mode only.
Understanding the last mode
memory feature
If the power is cut off while you are viewing the TV, the
Last Mode Memory feature automatically turns on the TV
when the power is resupplied.
Note: You should unplug the TV’s power cord if it is possible
that you will be away from the TV for an extended period of time
after the power is restored.
123-456
ANT
ABCHD
Stereo SAP
9:00pm
.
TV-PG L V1080i
16:9
123-456
ANT
MLB Young
,
s XXX...
Today
,
s Major League Baseball.
East 9:00pm-11:00pm
ABCHD
Stereo SAP
TV-PG L V1080i
16:9
50HM67_EN.book Page 55 Thursday, March 29, 2007 11:28 AM