Filter
Top Products
29
FUNCTION SETUP
Customizing the Function Settings
2. Press / to select Network List, then press OK. A
list of existing wireless networks near the BD player will
appear (It may take several seconds for this list to be
created). For example:
3. Press / to select the desired wireless network, and
press OK to confi rm.
a. If the BD player is connected to an Unencrypted
Wireless Network, a menu similar to the following will
appear:
4. Press
/ to highlight Connect, and press OK. If the
wireless network is functioning,
icon and a message
“Connection to XXX...Success” will appear on the TV.
5. Press OK to close the message. The BD disc player is
now connected to the network. From now on, when you
turn on the player, it will automatically connect to the
network; there is no need to repeat these steps again.
Note: If you do not see this message, the BD player was
not able to connect to the network.
Manual
WiFi Protected Setup (WPS)
IP Settings
Network List
Connection to the wireless Network which you I.
select
1. Press
/ to select Wireless, then press OK to confi rm.
the following screen will appear.
The symbols that might appear next to each listed wireless
network in the network list are as follows:
Category Icon Defi nition
Connected
When the BD player is
turned on, it will connect
to the wireless network
displaying this symbol.
Typically, this is the last
wireless network connected
before powering down.
Saved
The wireless network prop-
erties have been saved in
the BD player’s memory.
Wireless Security The wireless network data
is not encrypted.
The wireless network data
is encrypted; a ‘security key’
must be entered so that the
BD player can share data
over the network.
The wireless network data
is encrypted; the encryption
scheme is not supported by
the BD player.
Wireless Protocol
a
The wireless network sup-
ports 802.11a
b
The wireless network sup-
ports 802.11b
g
The wireless network sup-
ports 802.11g
n
The wireless network sup-
ports 802.11n
Signal Strength Strong Signal
Good Signal
Medium Signal
Weak Signal
No Signal
b. If the BD player is connected to an Encrypted
Wireless Network, a menu similar to the following will
appear:
4. Press ENTER to activate the on-screen keyboard.
Carefully enter the network password by using the
/
/ / to highlight the desired letter on the keyboard,
and then pressing OK. (If you make a mistake, use the
backspace key to erase the mistake.)
WiFi-me
Connect WPS Pin Delete Cancel
Password
WiFi-me
Press ENTER to open keyboard
Connect WPS Pin Cancel
WiFi
WiFi
Network List
WiFi
WiFi-me*
Panda
dlink_media
b
WiFi
g
NTGR 11g
b
WiFi
g
Airport_SN
bgn
a
a