Filter
Top Products
MANUAL SETUP
● On the Installation page, highlight “MANUAL
SETUP” and press the “ENTER” button.
● Select channel number. Be sure you know the
channel number and its RF frequency. You may
refer to Digital TV channel table on Appendix 1.
● Press “
▼” button to highlight “Frequency”,
“Bandwidth” and “Priority” to make sure the
parameters are correct, then press “
▼” button to
highlight “Start Scan” and press the “ENTER”
button to start scanning.
Note:
(1) If scanning is successful, “Start Scan” will change to “Get Channel Success” and signal quality will be
shown. At this point you can press “EXIT” to leave “MANUAL SETUP” or continue scanning other
channels.
(2) If scanning is unsuccessful, “Start Scan” will change to “Time out error”. At this point you can rescan the
signal or refer to the signal level bar “LVL” and bit error rate counter “BER” for aligning the direction of
the antenna to get the signal. Please refer to your Antenna Installer if problem persists.
(3) For Australia, the bandwidth should be 7MHz while for Singapore the bandwidth should be 8MHz.
Menu Navigation
RESET DATA
Zinwell to-do:
Add RESET DATA description here!
19