Toshiba PCS-1P VCR User Manual


 
134 Preparing for a multipoint videoconference
PCS -1/1P
3-207-456-12 (1)
I:\3207456121PCS1WW\08OPE.FM
masterpage:Left
Preparing for a multipoint
videoconference
Notes on installing the MCU software
You cannot install the software if the write-protect tab on the Memory Stick
in which the MCU software is stored is set to “LOCK”.
Once the MCU software is installed in the Communication Terminal, the
software will not be used again.
You cannot install the MCU software which is copied to another Memory
Stick with a computer, etc.
1 Set the power switch on the right side of the Communication Terminal to
the off position (
a).
2 Insert the “Memory Stick” containing the PCS-323M1 or PCS-320M1
MCU software into the Memory Stick slot.
Insert the “Memory Stick” in the direction of the arrow with the mark facing
upward.
3 Set the power switch on the right side of the Communication Terminal to
the on position (
@).
The MCU software is installed in the Communication Terminal.
To check if the installation of the software is completed
The installed software will be shown in “Software Option” of the Machine
Information menu.
For details on the Machine Information menu, see “Machine Information
Menu” on page 50.
Installing the MCU software
PCS-323M1 or PCS-320M1 MCU software