Filter
Top Products
ENG-70
Reference
Setting Control Codes
1. Press TV to set the remote control operating
your TV.
2. While holding down PROGRAM button enter
the two diglts of your TV’s brand code (listed
right) using number buttons.
3. Release PROGRAM.
4. Point the remote control at your TV and use
each button listed below to make sure your
TV is operated correctly.
TV POWER
To turn the TV on or off.
CH
To select TV channels in the upper or lower
direction.
TV VOL.
To adjust the sound level.
INPUT
To select an external source such as a VCR.
Number buttons
To select TV channels. When selecting
channels 1 to 9, first enter 0 and then the
desired number.
100
To substitute for 100 channel key.
DISPLAY
To turn on or off TV’s screen display.
ENTER
To use for the TV’s ENTER key.
Table of Brand Codes
Note
• Some TV’s may not respond to all the operations
above, or may not be operated at all with this
remote control. In this case, operate your TV with its
own remote control.
• For some brands, several control codes (brand
codes) are allocated. Try each of them until the
buttons work on your TV.
• If you replace the remote control’s batteries, set the
brand code again.
Controlling a TV with the Remote Control
The remote control can be compatible with various brands of TV by setting their
control codes. The TOSHIBA code has initially been set to control TOSHIBA TVs.
BRAND CODE
TOSHIBA PROGRAM + 01
RCA/GE PROGRAM + 02
SONY PROGRAM + 03
MITSUBISHI PROGRAM + 04
JVC PROGRAM + 05
HITACHI PROGRAM + 06
PANASONIC A PROGRAM + 07
SHARP NEW PROGRAM + 08
SANYO PROGRAM + 09
MAGNAVOX PROGRAM + 10
GOLDSTAR NEW PROGRAM + 11
SAMSUNG PROGRAM + 12
SHARP OLD PROGRAM + 13
ZENITH PROGRAM + 14
PANASONIC B PROGRAM + 15
PIONEER PROGRAM + 16
00839A-SD-6980SU-2 6/29/05 9:02 AM Page 70