Filter
Top Products
13
Appendix
Using the TV’s
Features
Setting up
your TV
Using the
Remote Control
Connecting
your TV
Welcome to
Toshiba
Important
Safeguards
Adding channels to the TV’s memory
When you press CH +/- on the remote control or CHANNEL ▲/▼ on
the TV front panel, your TV will stop only on the channels stored in the
TV’s channel memory. Follow the steps below to program channels into
the memory.
Programming channels automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory
automatically, you can add or erase specific channels manually.
To add channels automatically:
1. Press MENU, then press a or b to display the SETUP menu.
2. Press
c or d until the TV/CABLE
selection is highlighted.
3. Press a or b to highlight either TV
or CABLE, depending on which
you use.
If you use an antenna, choose TV.
If you use cable, choose CABLE.
4. Press
d to select CH PROGRAM.
5.
Press
a
or
b
to start channel programming. The TV will automatically
cycle through all the TV or Cable channels (depending on which you
selected), and store all active channels in the channel memory.
While the TV is cycling through the channels, the message
“PROGRAMMING NOW-PLEASE WAIT” appears.
6. When channel programming is complete, the message “COMPLETED”
appears.
7. Press CH + or – to view the programmed channels.
Adding and erasing channels manually
After you have programmed the channels automatically, you can add
or erase specific channels manually.
To add or erase channels manually:
1. Select the channel you want to add or erase.
If you are adding a channel, you must select the channel using the
Channel Number buttons.
2. Press MENU, then press
a or b to
display the SETUP menu.
3. Press c or d to highlight ADD/
ERASE.
4. Press
a or b to select ADD or
ERASE, whichever function you
want to perform.
5. Repeat steps 1–4 for other
channels you want to add or erase.
Changing channels
To change to the next programmed channel:
Press CHANNEL ▲/▼ on the TV front panel or CH +/– on the
remote control.
To change to a specific channel (programmed or unprogrammed):
Press the Channel Number buttons (0–9 and 100) on the remote
control.
For example, to select channel 125, press 100, 2, 5.
Menu
PICTURE AUDIO SETUP OPTION
CH
CH PROGRAM
ADD / ERASE
START
ADD
SELECT ADJUST
TV / CABLE TV CABLE
PICTURE AUDIO SETUP OPTION
CH
CH PROGRAM START
SELECT ADJUST
TV / CABLE CABLE
ADD / ERASE ADD ERASE
Channel +/–
Channel
Numbers
Setting up
your TV
c d a b
J3M61021A(E)_P07-13 12/1/06, 10:03 AM13