Filter
Top Products
16
1
Chapter
1
Introduction
Notes
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
Dispose of batteries in a designated disposal area.
Batteries should always be disposed of with the environment in mind.
Always dispose of batteries in accordance with applicable laws and regulations.
If the remote control does not operate correctly, or if the operating range becomes reduced, replace all batteries with
new ones.
When necessary to replace batteries in the remote control, always replace all batteries with new ones. Never mix
battery types or use new and used batteries in combination.
Be sure to use AAA size batteries.
Always remove batteries from remote control if they are dead or if the remote control is not be used for an extended
period of time. This will prevent battery acid from leaking into the battery compartment.
Caution
Never throw batteries into a fi re.
Point the remote control at the remote sensor and
press the buttons.
Distance
: About 7 m (23 ft) from
the front of the remote
sensor
Angle
: About 30° in each
direction of the front
of the remote sensor
Open the cover.
Insert batteries.
7
Use 4 batteries (AAA sizes).
7
Make sure to match the + and – on the batteries
to the marks inside the battery compartment.
Close the cover.
11
22
33
Set up the remote control to operate the player and your TV.
Preparation of the remote control
Loading batteries
Operating with the remote control
The remote control has a backlight function for
conveniently illuminating the buttons when you use the
remote control in a dark room, etc.
Lights for approximately 10 seconds when a button is
pressed.
The backlight function is off by default.
About the remote control backlight
To turn on the backlight function
Press and hold for at least three
seconds.
To turn off the backlight function, press and hold
again for at least three seconds.
Notes
Using the backlight function shortens the lifespan of
the batteries.
The backlight function turns off if the batteries in the
remote control are replaced.
HD-XA2KN_01_E.indd 16HD-XA2KN_01_E.indd 16 06.12.5 0:22:58 PM06.12.5 0:22:58 PM