Toshiba MW24F11 DVD VCR Combo User Manual


 
Introduction
12
Operation:
Aim the remote control at the remote sensor and press control buttons to
operate.
Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of approx. 5 meters.
Replace the compartment
cover.
Install two “R03/AAA” batteries
(supplied),
paying attention to the
polarity diagram in the battery
compartment.
Open the battery compart-
ment cover in the direction of
the arrow.
Press POWER to turn the unit on or off.
Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD.
•Tap CH
or to move through the channels one channel at a time.
The Direction buttons (
/ / / ) are also used to navigate on-screen menu system.
•You can directly access specific channels using Direct channel selection buttons.
1
23
Remote control basics
Inserting batteries
Approx. 5 meters
Illustration of MW20F11
Identification of controls (Continued)
Caution:
•Never throw batteries into a fire.
Notes:
Be sure to use AAA size batteries.
Dispose of batteries in a designated disposal area.
Attention should be drawn to the environmental aspects of battery disposal.
Do not mix different battery types or combine used batteries with new ones.
If the remote control does not operate correctly, or if the operating range becomes reduced, replace both
batteries with new ones.
If the batteries are dead or if you will not be using the remote control for a long time, remove the batteries to
prevent battery acid from leaking into the battery compartment.
5T40301A [E]p06-12 3/1/05, 10:1512