Filter
Top Products
12
Using the
Remote Control
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL MUTE
CH
CH
VOL VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REWPAUSE
FF
SOURCESTILL
PIP
SLOW
PIP CH LOCATE SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEOFAV CH
A
EXIT
CT-90037
Using the remote control to operate a VCR or cable TV converter
• If you have a non-Toshiba VCR or cable TV converter, you must first program the remote control to recognize your
VCR or converter brand (see pages 13–14).
• To use your TV remote control to operate a VCR, set the TV/CABLE/VCR switch to VCR. The shaded buttons in the
picture below will then operate the VCR instead of the TV.
• To use your TV remote control to operate a cable TV converter, set the TV/CABLE/VCR switch to CABLE. The
shaded buttons shown in the picture below will then operate the converter instead of the TV.
Point the remote control at the VCR or cable TV converter
REC
Starts tape recording.
SLOW
In play mode, press to view a
slow-motion picture.
FF
Fast-forwards the tape.
In play mode, press to view the picture
moving rapidly forward.
REW
Rewinds the tape.
In play mode, press to view the
picture moving rapidly backward.
PLAY
Begins tape playback.
STOP
Stops the tape.
CHANNEL s/t
s selects the next higher channel,
and t selects the next lower channel.
ENTER
Required by some VCRs and cable TV
converters to change the channel.
POWER
Turns the VCR (or cable TV
converter) on and off.
Channel Numbers
Press to directly access channels (as
opposed to the Channel s/t buttons).
TV/CABLE/VCR Switch
Set to CABLE to control the
cable converter; set to VCR to
control the VCR.
TV/VCR
To view one program while
recording another, press to select
TV mode.
PAUSE
In play or record mode, press to freeze
the picture; press again to release.