Toshiba W-708 VCR User Manual


 
28
6
Move to the next using
FF
, and set
the hour and minutes of the
recording start time.
7
Move to the next, and set the
recording off time.
8
Move to the next, and select the tape
speed (SP) using
PLAY/x2
or
STOP
.
For the tape speed “AUTO (Auto Speed
Select)”, see below.
To set another program, press
FF
, and
select the next line pressing
STOP
.
Repeat steps 4 to 8.
9
Press
PROG.
.
Now programming is completed.
10
Press both
TIMER
simultaneously.
The power turns off and the VCR enters
the timer standby mode.
Auto Speed Select
If you are not sure the tape is long enough for
timer program recording in the SP tape speed,
set the recording tape speed to “AUTO”.
Recording starts in the SP tape speed and the
VCR automatically selects the tape speed to
record the program to the end. If the tape length
is not long enough, the tape speed automatically
changes from SP to SLP.
TIMER
POWER
Timer Program Recording (continued)
TIMERREC
PROG
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
25 8
/
30
:
30
–:––
SLP
ED:
n
O
n
CH DATE OFF DPS
P
M
PROGRAM
SET UP
PRESET
9
PROG
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
25 8
/
30 9
:
30
:00
ED:
n
O
n
CH DATE OFF DPS
P
M
P
M
SLP
PROGRAM
SET UP
PRESET
10
PROG
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
–– –/–– –:–– –:––
25 8
/
30 9
:
30
10
:00
ED:
n
O
n
CH DATE OFF DPS
P
M
P
M
SP
PROGRAM
SET UP
PRESET
Notes
Make sure that the tape length is selected correctly
according to the tape used on the SET UP screen
(page 24).
When the SLP tape speed is selected and the tape
length is not sufficient to record the program to the
end, the program cannot be recorded to the end.
The picture will be distorted when playing the part
where the recording tape speed is switched from
SP to SLP with the Auto Speed Select feature.