Tripp Lite B125-101-60-WP TV Cables User Manual


  Open as PDF
of 4
 
TMDS
UP TO 125 ft. (Cat6)
UP TO 75 ft. (Cat5)
LOCAL
TRANSMITTER
BLU-RAY
1080p (6o Hz)
1080p (6o Hz)
REMOTE
RECEIVER
DDC
B125-101-60-WP Installation Diagram
3
1
ConnecttheHDMIsourcetotheHDMIinputonthelocaltransmitter
unit.
2
Connect the TMDS RJ45portonthelocaltransmittertotheTMDS
RJ45portontheremotereceiverusingCat5e/6cable.
Note: See the installation diagrams for maximum extension
distance at 1080p (60Hz) video resolutions.
3
Connect the DDC RJ45portonthelocaltransmittertotheDDC
RJ45portontheremotereceiverusingCat5e/6cable.
Note: See the installation diagrams for maximum extension
distance at 1080p (60Hz) video resolutions.
4
ConnecttheHDMIoutputontheremotereceivertotheHDMImonitor.
5
Connecttheexternalpowersupplytotheremotereceiver,andthen
plugitintoaTrippLiteSurgeSuppressor,UninterruptiblePower
Supply(UPS),orPowerDistributionUnit(PDU).TheGreenLEDson
both the local and remote units will illuminate to indicate that power
isbeingreceived.TheOrangeLEDontheremoteunitwillilluminate
toindicatethataconnectionhasbeenmadewiththelocalunitvia
Cat5e/6cable.
6
TurnonthepowertotheHDMIsource.TheOrangeLEDonthelocal
unitwillilluminatetoindicateitisreceivingasignalfromthesource.
7
Ifnecessary,usetheequalizationcontroltoadjustthevideoimage.
Note: An improper Equalization setting can result in no image being
displayed at all. Try each Equalization setting until an acceptable
picture is displayed.
Installation and Operation
201109193-93-3144.indd 3 10/7/2011 2:29:40 PM
 previous