Tripp Lite B126-1A1-WP TV Cables User Manual


  Open as PDF
of 28
 
12
Extender Kit with Remote/Repeater Installation
11
Toaddathirdremote/repeaterunit,repeatsteps8through10.
TonishyourinstallationwiththeB126-1A1orB126-1A1-WP
remote receiver unit, proceed to step 12.
12
UsingCat5e/6cable,connecttheRJ45OUTPUTportonthelast
remote/repeaterunittotheRJ45INPUTportoftheB126-1A1or
B126-1A1-WP remote receiver unit.
13
Connect a monitor to the HDMI OUTPUT port on the remote receiver
unitusingaTrippLiteP568-SeriesHDMICable.
14
Connect the external power supply to the remote receiver unit and
plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The green
LED illuminates to indicate the unit is receiving power from the
external power supply. The orange LED illuminates to indicate the
unitisconnectedtoapoweredONremote/repeaterunit.
15
Turn on the power to the HDMI source. The orange LED on the
local unit illuminates to indicate a signal is being received from the
source.
16
If necessary, use the Equalization control on the remote/repeater
unit(s) and remote receiver unit to adjust the video image. Note: An
improper Equalization setting can cause the monitor not to display
a picture at all. Try each Equalization setting until an acceptable
picture is displayed.
201109206-93-3023-EN.indd 12 10/24/2011 10:01:21 AM
 previous next