Tripp Lite B126-1P0-WP-1 TV Cables User Manual


  Open as PDF
of 28
 
18
Extender/Splitter with Remote/Repeater Installation
10
Connect the external power supply to the remote/repeater unit and
plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The green
powerLEDandthegreenRJ45LEDsilluminatetoindicatetheunit
is receiving power.
11
Toaddathirdremote/repeaterunit,repeatsteps8through10.
TonishyourinstallationwithaB126-1A0orB126-1A0-WP-1
remote receiver unit, proceed to step 12.
12
UsingCat5e/6cable,connecttheRJ45OUTPUTportonthelast
remote/repeaterunittotheRJ45INPUTportonaB126-1A0or
B126-1A0-WP-1 remote receiver unit.
13
Connect a monitor to the HDMI OUTPUT port on the remote receiver
unitusingaTrippLiteP568-SeriesHDMICable.
14
Connect the external power supply to the remote receiver unit and
plug it into a Tripp Lite Surge Suppressor, PDU or UPS. The green
LED illuminates to indicate the unit is receiving power from the
external power supply. The orange LED illuminates to indicate the
unitisconnectedtoapoweredONremote/repeaterunit.
15
Repeatsteps5through14foreachadditionalRJ45outputporton
the local transmitter unit.
16
TurnonthepowertotheHDMIsource.TheorangeRJ45LEDson
the local unit illuminate to indicate a signal is being received from
the source.
17
If necessary, use the Equalization control on the remote/repeater
unit(s) and remote receiver unit to adjust the video image. Note: An
improper Equalization setting can cause the monitor not to display
a picture at all. Try each Equalization setting until an acceptable
picture is displayed.
201109206-93-3023-EN.indd 18 10/24/2011 10:01:23 AM
 previous next