Unisen LT-46151 Flat Panel Television User Manual


  Open as PDF
of 96
 
12 1. Basic Setup and Operation
Setting Up Other Inputs
ConnectyourdevicestotheTV,makingnoteof
1.
whichTVinputjackisusedforeachdevice.See
“TVConnections,”page16,forrecommendations.
Poweronthedevicestoensuredetection.
2.
PowerontheTV.
3.
TheTVwilldisplaytheNew Device Foundscreen
foreachnewconnectionitdetectsLearnmore
aboutAutoInput/AutoOutputSensingonthe
oppositepage.
Selectthedevicetypeifthedeviceisnotrecog-
4.
nizedautomatically.
Sample New Device
Found screen.
153 and 249 Series.
5.
YoucanperformNetCom-
mandIR“learning”afterselectingthedevicetype
oratalatertimewhenconvenient.Toperformnow,
highlightNetCommandandpress
ENTER
.See
“InitialNetCommandSetup,”page57or“SettingUp
A/VReceiverControl,”page62.
Important Note for NetCommand IR Users
153 and 249 Series. Besuretoselectthecorrect
devicetypehere.Althoughyoucanchangethe
devicetypelaterintheInputs>Namemenu,any
“learned”NetCommandIRcodeswillbeerased
whenyoumakethechange.
Press
6.
BACK
toclosetheNew Device Foundscreen.
TheTVwillthendisplaytheNew Device Found
screenforthenextconnectionitfinds.
Channel Scan for Digital Channels
If you skip this step, the TV cannot receive digital
channels.
Ifusinganantennaordirectcableservice(nocable
box),connecttheincomingcoaxialcabletotheTV’s
ANT
input.Refertopage21.
Youmustperformachannelscantoenablereception
ofallavailablehigh-definitionandstandard-definition
digitalchannels.Thechannelscanwillsearchfor
channelsavailablelocallyandsavethemtomemory.
Memorizing Channels with Channel Scan
For the ANT input
To start channel memorization
PowerontheTV.
1.
Press
2.
MENU
andopentheInitial > Channelmenu.
Start channel memorization from the Initial > Channel
menu.
Press
3.
ENTER
toenterthemenu.
Select
4.
Ant Airifconnectedtoan
over-the-airantenna.SelectAnt
Cablefordirectcable(service
withoutacablebox).
Highlight
5.
Scanandpress
ENTER
.
Channelmemorizationmaytakeup
to15minutestocomplete.
To stop channel memorization before completion,
press
CANCEL
.
UsetheInitial > Channel>Editmenu(page48)for
additionalchanneloptions,suchasaddingordeleting
channelsfrommemory.
Setting Up TV Inputs
Downloaded From TV-Manual.com Manuals
 previous next