Filter
Top Products
16
PROGRAMMING THE F1 KEY
FOR SPECIFIC CHANNELS
The Cogeco Atlas DVR 5-Device Universal Remote Control
includes a programmable F1 key (located directly below the
LAST key).
The F1 key can be programmed to remember five of your
favorite cable channel settings. If you want to change the
cable channels previously-programmed on the F1 key,
you’ll need to clear the key first (see the next page).
To Program The F1 Key:
1. On the remote control,press CBL once; it will
blink once.Then press and hold SETUP until
the CBL key blinks twice,then release SETUP.
2. Enter 9 - 9 - 5.The CBL key will blink
twice. Then select the F1 key and press
it once.
3. Press CBL once followed by the channel
number to be programmed (e.g.,0 - 3 - 9).
4. Press and hold SETUP until the CBL key blinks
twice, then release SETUP.
5. To add another channel, repeat steps 1
through 4, substituting the new channel to be
added in step 3.
NOTE: Programming more than five channels on the
same
F1
key will overwrite previous settings.
Atlas DVR M1055F1 9/3/04 7:30AM Page 16