Filter
Top Products
19
To Clear The Master Power Key:
1. Perform steps 1 and 2 in the first section
above, To Program The Master Power Key.
2. To clear the settings and exit the program,
press and hold SETUP until the CBL key blinks
twice, then release SETUP.
RE-ASSIGNING DEVICE KEYS
The Atlas DVR/PVR 5-Device Universal Remote Control
can be set up to control a second device. For example,
to have the unit control a TV, a Cable Converter, and two
DVD Players, you will need to re-assign the unused AUX
key to operate the second DVD Player as follows:
NOTE:
AUX
is preset at the factory to control an RCA VCR.
Performing the below steps will overwrite those settings.
1. On the remote control,press AUX once; it will
blink once. Then press and hold SETUP until
the AUX key blinks twice, then release SETUP.
2. Enter 9 - 9 - 2.The AUX key will blink twice.
3. Press DVD once, then press AUX once. The
AUX key will blink twice.
4. The AUX key is now ready to be programmed
for your second DVD player.See Programming
Device Control on page 10.
To re-assign other device keys,repeat steps 1 to 4 and
substitute the key sequence using the following chart:
NOTE:Only one device can be assigned to an unused device key
at a time.
continued on next page...
Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 19