Filter
Top Products
www.urcsupport.com
18
PROGRAMMING ID LOCK
The Atlas DVR/PVR 5-Device Universal Remote Control
with Learning is locked at the factory to operate a
Scientific Atlanta cable converter. However, if you have
another brand or model of cable converter or satellite
service that you would like to control, then you’ll need to
perform the following steps to unlock the ID Lock, enter
a new manufacturer’s code, and lock the ID Lock again.
1. Turn on the cable converter.
4. Perform the instructions under
“Programming Device Control” on page 8 to
program device control for the desired cable
converter or satellite receiver.
When you are done, perform steps 5 and 6 on
this page to again lock the ID Lock.
PROGRAMMING TUNE-IN
KEYS FOR SPECIFIC CHANNELS
The Atlas DVR/PVR 5-Device Universal Remote Control
with Learning includes three Tune-In keys (located
directly below the MUTE and LAST keys). Each can be
programmed to remember five of your favorite cable
channel settings for a total of fifteen channels. If you
want to change the cable channels in a previously-
programmed Tune-In key, you’ll need to clear the key
first (see “Clearing a Tune-In Key” on page 19).
2. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice.
3. Enter 9 8 2. The CBL key will blink four
times, indicating ID Lock is unlocked.
5. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice.
6. Enter 9 8 2. The CBL key will blink twice,
indicating ID Lock is again locked.