Filter
Top Products
5. Press SETUP once to lock in the code.The TV
key will blink twice.
6. To search for the codes of your other devices,
repeat steps 1 through 5,but substitute the
appropriate key (e.g.,AUX, DVD, AUD, or CBL)
for the device you are searching for.
CHECKING THE CODES
If you have set up the Atlas DVR/PVR 5-Device Universal
Remote Control using the Searching For Your Code
procedure (on the previous page),you may need to find
out which four-digit code is operating your equipment.
For example,to find out which code is operating your TV:
1. On the remote control,press TV once; it will
blink once.Then press and hold SETUP until
the TV key blinks twice,then release SETUP.
2. Enter 9 - 9 - 0.The TV key will blink twice.
3. To view the code for the first digit,press 1
once.Wait 3 seconds and count the number
of times the TV key blinks (e.g.,3 blinks = 3)
and write down the number in the leftmost
TV Code box on page 11.
NOTE: If a code digit is “0”,the selected mode key
will not blink.
4. Repeat step 3 three more times for the
remaining digits.Use 2 for the second digit,
3 for the third digit,and 4 for the fourth digit.
Finish writing down the code in the TV Code
boxes on page 11.
5. To check for other device codes,repeat steps
1 through 4,but substitute the appropriate key
(e.g.,AUX, DVD, AUD, or CBL) for the device
you are checking.Write down the codes in the
appropriate boxes on page 11.
25
Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 25