Filter
Top Products
e. Then, press and release the device key (TV, VCR, DVD or STB) again.
The LED lamp will blink three (3) times. This will indicate the remote is
correctly set for that device. It will also take the remote out of the programming mode.
f. Test the other buttons (especially numeric keys) to see if the remote operates all
the functions of your device. If it does, you're finished. If it does not,
repeat steps a. – e. until you find the correct code for your device.
*Note:
. During programming, if no key is pressed within 20 seconds of the previous keystrokes, the remote
will exit the programming mode.
2. Code Search Programming
To program your remote using Code Search Programming, follow the steps below:
a. Turn on the device to be operated (TV, VCR, DVD, or STB).
b. Press and hold the device key to be operated (TV, VCR, DVD, or STB) and the OK key at the
same time and hold both for about 3 seconds until the LED stays on.
c. Point the remote at your device, then press and release the CH+ [or CH-] key to increase [or
decrease] the code number by one digit. Continue pressing and releasing the CH+ [or CH-] key
until the equipment turns off. You may need to do this for several minutes while the remote
searches for the correct code.
d. When the device turns off, press and release the POWER button to ensure your device responds
to the remote.
e. Then, press and release the device key (TV, VCR, DVD or STB) one more time. The LED will
blinks three (3) times. This will indicate the remote is correctly set for that device. It will also
take the remote out of the programming mode.
g. Test the other buttons (especially numeric keys) to see if the remote operates all of the
functions of your device. If it does, you're finished. If it does not, repeats steps a. – e. until you
find the correct code for your device.
*Note:
During programming, if no key is pressed within 20 seconds of the previous keystrokes, the remote
will exit the programming mode.
3.Auto Scan Programming
To program your remote using Auto Scan Programming, follow the steps below:
a. Turn on your device (TV, VCR, DVD, or STB).
b. Press and hold the device key to be operated (TV, VCR, DVD, or STB) and the OK key at
the same time and hold for about 3 seconds until the LED stays on.
c. Point the remote at your device, then press and release the PLAY button. The remote will start to
scan the codes one by one. Wait until your device turns off. You may need to wait for several
minutes until the remote finds the correct code. [If the remote completely scans all the codes for
the corresponding device, the LED will stay on.
3