Filter
Top Products
E - 3
Before turning on your television set for the fi rst time, be sure to place it on a solid stable surface. To avoid
danger, do not expose the TV to water, or a heat source (e.g. lamp, candle, radiator). Do not obstruct
the ventilation grid at the rear and be sure to leave suffi cient gaps around the unit as shown.
QUICK INSTALLATION
TURNING ON THE UNIT FOR THE FIRST TIME
The fi rst time you turn on the unit, the unit will enter the setup mode. The unit will guide you through
initial setup with easy-to-follow menus on the TV’s screen.
Make sure the TV antenna or CATV cable has been connected properly to the TV
antenna input jack on the rear of the system.
1. Connect the TV antenna.
2. Connect the power cord.
3. Press the / ON button to turn on the unit.
4. Press the
/ button to highlight Antenna,
then use the ENTER or button to select
“Air”, “Cable STD”, “Cable HRC”, “Cable IRC”
or “Cable Auto“.
5. Use the
/ button to highlight Auto
Scan, then press the ENTER or button to
confi rm.
6. The unit will immediately search all channels
for those with adequate signal strength and
store those channels with signals in memory.
The unit will take a few minutes to fi nish auto
scan and after this is completed, the unit will
switch to the fi rst channel found.
If you subscribe to Cable TV Service, we
recommend you pick “Cable Auto”, however
you might fi nd you get improved results using
“Cable STD”, “Cable IRC”, or “Cable HRC” -
these are different standards used by various
Cable Systems.
To Stop
Menu
Analog Air Channel 10
Analog Channels Found
Autoprogram Menu
Digital Channels Found
Progress(%) 5
0
0
Not Found
To Move To Select To Exit
Enter
Menu
OSD Language
Antenna
Initial Setup Menu
Auto Scan
Air
English
2 3/8"
2 3/8"
2 3/8"
PLV76156S7_ENG_IB_UL_091221.indd 3PLV76156S7_ENG_IB_UL_091221.indd 3 12/22/2009 10:46:0312/22/2009 10:46:03