Filter
Top Products
Installation
Vidikron VL-40 and VL-46 Owner’s Operating Manual 21
PRE
L
IMINAR
Y
Connecting External
Speakers (Optional)
The DView is equipped with stereo speakers, which are mounted directly below the screen. If
you prefer, you can connect the rear-panel speaker outputs to external speakers.
Connect the (positive) and (negative) speaker wires to the rear-panel SPEAKER-R and
SPEAKER-L terminals; see Figure 3-8. Maintain the correct polarity. For more information,
refer to the owner’s manual for your speakers.
Figure 3-8. External Speaker Connection
You can also remove the built-in speakers if they are not needed; this permits installation of
the display in locations where space above and/or below it is very limited. See
Figure 3-9.
Figure 3-9. Removing the Built-in Speakers
12 mm
Twist exposed
wire strands
together.
Right Speaker Left Speaker
Push tab to the
open position, and
insert the wire.
Then, close tab firmly to
secure the wire in place.
Remove these screws to allow the speakers to be detached.