Filter
Top Products
Operation
Vidikron PlasmaView Owner’s Operating Manual 45
PRE
L
IMINAR
Y
Front L.E.D.: Select Front L.E.D. from the Option menu to change the behavior of the
front-panel STANDBY/ON indicator LED (Figure 2-1). When set to ON, the LED indicates
operating status as follows:
• Lights green to indicate normal operation;
• Flashes green (once per second) when the AUTO OFF feature is active;
• Lights red to indicate that the PlasmaView is in standby mode;
• Flashes green or red (twice per second) to indicate an error condition.
When set to OFF, the LED lights red when the PlasmaView is in standby mode; otherwise, it is
off.
ISF Settings: The PlasmaView provides two “color modes,” NORMAL and ISF CCC. This allows
you to create two, independent sets of image quality settings and switch from one to the
other by selecting a color mode.
Select ISF Settings from the Option menu. Then, press SET to select either NORMAL or
ISF CCC. Any subsequent changes to image quality settings are stored and can be recalled by
selecting that color mode.
Vidikron Pro: Select Vidikron Pro from the Option menu to access these advanced image
processing settings.
• Underscan: Underscan causes the outer edge of the display to appear beyond the normal
effective data area for a video signal.
To use Underscan, select it from the Vidikron Pro menu and set it to ON. Then, exit the
menu system and use the ASPECT RATIO remote control button to select Underscan
mode.
• Display Profile: Select NORMAL or PURE to see the normal color gamut. Select
MONOTONE to remove all color information from the image. Select HIGH CNT to increase
the color temperature by approximately 2,000K.
• Signal Type: For most source material types, the appropriate Signal Type setting is
MOTION. However, with certain interlaced and/or composite video images with few or no
moving objects, STILL or NON-STD may yield better results.
Select Return to exit the Vidikron Pro menu.
FRC: Select FRC from the Option menu to enable frame rate conversion. Set FRC to NORMAL
if you notice and want to minimize motion blur when viewing source material that
originated from film. If frame rate conversion is not needed, set FRC to SCALER.
Power On Mode: Select Power On Mode from the Option menu to specify which input
signal is displayed when you turn on the PlasmaView. You can also specify an initial audio
volume level.
You can select a specific input or volume level (0 to 42). Or, select LAST to have the
PlasmaView set the input and volume to what they were the last time it was turned off.
The ISF CCC color mode is pre-set to approximately 3,200K.
Note
INPUT 3
INSTALLER ADJ.
SCREEN
SET-UP
OPTION
PICTURE
ENTERSET
EXIT
MENU
: OFF
: OFF
POWER ON MODE
SEAMLESS SW
PICTURE ORIENT.
FUNCTION RESET