Filter
Top Products
ViewSonic 20 PJ260D
1. Turn off the projector.
2. Unplug the power cord.
3. Place a protective sheet (cloth)
beneath the projector. Turn the
projector over so you can access
the lamp cover.
4. Loosen the screw in the lamp cover
and remove the cover.
5. Remove the screws from the lamp
module, raise the handle, and lift
out the module.
6. Insert the new lamp module into the
projector and tighten the screws.
7. Replace the lamp cover and tighten
the screw.
8. Turn on the projector. If the lamp
does not turn on after the warm-up
period, try reinstalling the lamp.
9. Reset the lamp hour. Refer to the
“Setting (Computer / Video Mode)”
menu.
Dispose of the used lamp according to local regulations.
Ensure that screws are tightened properly. Screws not tightened fully may
result in injury or accidents.
Since the lamp is made of glass, do not drop the unit and do not scratch the
glass.
Do not reuse the old lamp. This could cause the lamp to explode.
Be sure to turn off the projector and unplug the AC power cord before
replacing the lamp.
Do not use the projector with the lamp cover removed.