Filter
Top Products
ViewSonic VX912 7
Using the LCD Display
Setting the Timing Mode
Setting the timing mode is important for maximizing the quality of the screen image and
minimizing eye strain. The timing mode consists of the resolution (example 1280 x 1024) and
refresh rate (or vertical frequency; example 75 Hz). After setting the timing mode, use the
OnView
®
controls to adjust the screen image.
For the best picture quality set your LCD display timing mode to:
VESA 1280 x 1024 @ 60Hz.
To set the Timing Mode:
1. Set the resolution: Right-click on the Windows desktop > Properties > Settings > set the
resolution.
2. Set the refresh rate: See your graphic card's user guide for instructions.
WARN IN G: Do not set the graphics card in your computer to exceed the maximum refresh
rate of 85Hz/1280 x 1024@75Hz; doing so may result in permanent damage to your LCD
display.
OSD and Power Lock Settings
• OSD Lock: Press and hold [1] and the up arrowSfor 10 seconds. If any buttons are pressed
the message OSD Locked will display for few seconds.
• OSD Unlock: Press and hold [1] and the up arrowSagain for 10 seconds.
• Power Button Lock: Press and hold [1] and the down arrowTfor 10 seconds. If the power
button is pressed the message Power Button Locked will display for few seconds. With or
without this setting, after a power failure, your LCD display’s power will automatically turn
ON when power is restored.
• Power Button Unlock: Press and hold [1] and the down arrowTagain for 10 seconds.