Filter
Top Products
VIZIO320VLandE370VLUserManual
Chapter 5 Using your HDTV for the first time
Select an Input Source
Select the input source for your HDTV by pressing the INPUT button on
the remote control or the front of your TV. Pressing this button will cycle
you through the following options: TV, AV, Comp, HDMI-1, HDMI-2, RGB,
and Media.
Turn on your device and you will see a picture on your HDTV. If there is no
picture, make sure you have selected the correct input on your HDTV.
Note: If the selected device is RF connected, your HDTV needs to be in
TV mode and on either channel 3 or channel 4 matching the channel which
has been selected on the back of the VCR, Cable Box, External TV Tuner
or Satellite Receiver. Refer to Owner or User's Manual of such equipment
for details.
Watching a TV Program
Before you start watching TV, make sure that any cable, satellite or off-air
antenna connections are secure. Also, verify that the AC/DC power
adapter is plugged into a correctly grounded electrical outlet or surge protector.
1. Press the power button on the remote control. The VlZlO logo on the front will light up white.
2. Select the input to which your device is connected that provides TV programming (i.e. TV, HDMI,
COMP).
Note: You should be able to see a picture. If you do not, make sure that all of your HDTV connections
are secure and you have selected the correct video input source. Each press of the INPUT button on the
remote control will cycle through the available inputs. Press the button until the input associated with the
device you want to view is shown.
3. When using the TV input, press the channel buttons on the remote control or the TV to change
the channel. The channel buttons will not work if you are watching a program using HDMI,
Component, or AV inputs.
18
www.VlZlO.com