Filter
Top Products
VIZIO VF551XVT User Manual
Version 7/17/2009 53
www.VIZIO.com
Chapter 7 Programming the VIZIO Universal Remote Control
Using a Cable or Satellite Box Remote
Your VIZIO remote uses codes 000, 047, 050, 067, 329, 331 and 339 to work your HDTV. To use a cable
or satellite remote to work the HDTV, refer to your cable or satellite remote user guide for more
information on how to program the remote.
If your cable or satellite remote uses a 5-digit code (like most Direct TV units), first try 11758 and then, if
that does not work, 10178. If your cable or satellite remote uses a 4-digit code, try 1758 and then 0178 as
an alternative. If your cable or satellite remote uses a 3-digit code (Echostar or Dish Network for example),
use code 627.
Note: Some buttons may not function as expected on your cable or satellite remote. Typically power,
volume and mute will work.
Programming other devices
Your remote control is programmable and supports up to three different devices. Listed below are the
steps for programming your DVD player, Home Theater System, and a Cable or Satellite box. Once you
find your codes, write them in the table provided.
Programming your DVD Player
1. Turn on the DVD player.
2. Press and release the DVD button on the remote control.
3. Press and hold the SET button until the LED flashes twice.
4. Find the programming code for your DVD player in the code list below and enter it using the
number buttons. If the code is accepted, the LED flashes twice after the last digit is entered. If
the LED does not flash twice, repeat Steps 2 through 4 with the next code listed.
5. Point the remote control at the DVD player and press the POWER button. The DVD player will
turn off. If the DVD player does not turn off, repeat Steps 2 through 4 with the next code listed for
the component and manufacturer.
Notes:
If the codes do not work or your brand is not listed, see “Searching for Component Codes.”
Sometimes a code listed will only include limited functions. Try other codes that may include
more functionality.
Programming your Home Theater System
1. Turn on the home theater system.
2. Press and release the AUDIO button on the remote control.
3. Press and hold the SET button until the LED flashes twice.
4. Find the programming code for your home theater system in the code list below and enter it using
the number buttons. If the code is accepted, the LED flashes twice after the last digit is entered.
If the LED does not flash twice, repeat Steps 2 through 4 with the next code listed.
5. Point the remote control at the Home Theater System and press the POWER button. The Home
Theater System will turn off. If the Home Theater System does not turn off, repeat Steps 2
through 4 with the next code listed for the component and manufacturer.
Notes:
If the codes do not work or your brand is not listed, see “Searching for Component Codes.”
Sometimes a code listed will only include limited functions. Try other codes that may include
more functionality.