Filter
Top Products
VIZIO
®
VW32L HDTV40A User Manual
Version 10/17/2008 11
www.VIZIO.com
1.4 VIZIO Remote Control
GUIDE – This button displays program information. Press this button once and the information of the
program being viewed is shown.
POWER – Press this button to turn the TV on from the Standby mode. Press it again to return to the
Standby mode.
TV – Press this button to select TV.
AV – Press this button to select the Audio Video input. Pressing this button
repeatedly will get you to the AV input. Keep in mind that if S-Video cable is
being used, then AV will show the signal going through this input as the S-
video takes priority.
COMPONENT – Press this button to select the Component (YPbPr) input.
Pressing this button repeatedly will take you through the Component
(Component 1 and component 2) inputs.
HDMI – Press this button to select the HDMI input. Pressing this button
repeatedly will get you through the HDMI (HDMI1, and HDMI 2) different
inputs
MENU – Use this button for the On-Screen Display (OSD) menus. When use
within the OSD menus, pressing this key will make the selection of an option.
- These buttons navigate the On-Screen Display (OSD).
MUTE – This button turns the sound on and off.
LAST – This button recalls the previously viewed channel when it is used in
TV mode; meaning that the TV unit has control over the signal or program
being watched. This button also has different functions when being used in
conjunction with the On-Screen Display (OSD) menu.
VOL (+ or -) – These buttons turn the volume up or down.
CH (+ or -) – These buttons change the
channels up or down.
Number Button Pad – Use these buttons
to select a channel or enter a password.
INPUT – This button allows the user to
cycle through the inputs. Repeatedly
pressing of this button will step you through
the input sources in the following
sequence: TV, AV (S-Video), COMP1,
COMP2, RGB, HDMI1 and HDMI2. Once
you have stepped through the entire
sequence, you will return to the beginning.
- (DASH) – When selecting a digital
channel directly, use this button for the
separation of main and sub-channels. For example, channel 28-2 would be selected by the button
sequence 2 8 --2.